HPI Bullet 3.0 MT/ST Front Tyre and Alloy Beadlock Rim Kit BMT1003F+889 by GPM  [BMT1003F+889]

Front tyre and beadlock kit for HPI Bullet 3.0 MT/ST nitro

This aftermarket set supplies front rubber tyres on nylon rim frames with alloy 10-pole beadlock rings and includes 12x9mm drive adapters for HPI Bullet 3.0 MT and ST nitro chassis. The kit is a scale-accurate replacement aimed at restoring steering feedback while allowing straightforward front-end adjustments.

To install, remove the original front wheels, fit the 12x9mm drive adapters to the existing hex or axle interface, seat the tyre on the nylon rim and secure the alloy beadlock ring with the supplied hardware. Always confirm adapter and hub compatibility before running.

The beadlock design permits tyre swaps and small stagger tuning while the nylon rim frames reduce the chance of impact damage. Alloy 10-pole beadlocks clamp the tyre to maintain consistent steering response across different surfaces. Check beadlock screws and adapter tightness following initial runs.

Use this set to replace worn front tyres or to trial modest front-end setup changes on HPI Bullet 3.0 MT/ST nitro models; avoid overtightening adapters and inspect beadlock fasteners regularly.