HPI Bullet 3.0 MT/ST Shock Tower Replacement - BUL-18005-BK by Jazrider  [BUL-18005-BK]

Component overview

This is an alloy front and rear shock tower assembly for scale RC use, featuring an integrated body mount and supplied as a single piece. The part is intended for HPI Bullet platform models listed as Bullet 3.0 MT and ST in official parts references. Precision-machined alloy construction replaces plastic towers to provide a firmer mounting point for shocks and the body mount while limiting extra mass.

The towers secure the top mounts of the suspension, support consistent shock geometry under load, and create a reliable anchor for the body. Prior to fitting, confirm your chassis follows the Bullet 3.0 layout and that the mounting holes align. Use standard RC care when removing original components and fitting alloy replacements to avoid thread or hardware damage.

Fitment notes: the towers locate at the factory shock tower positions and generally use the original mounting points and hardware unless your chassis notes otherwise. The stiffer mounting surface can influence shock characteristics, so re-check damping and ride height after installation.