HPI Bullet Compatible Alloy Shock Tower Set BUL-18005-GU by Jazrider  [BUL-18005-GU]

Notes on fitment and tuning

This alloy front/rear shock tower set is designed for use with the HPI Bullet chassis and is supplied as 1 pcs in gunmetal. The integrated single-piece tower incorporates body mount positions and provides a stiffer anchoring point for shock absorbers and body posts than the original plastic towers.

The primary role of the component is to increase rigidity at suspension mounting areas and to stabilise body mounts under cornering and impact. As a tuning tool it changes how suspension loads are routed through the tower, helping retain correct shock geometry during dynamic loads.

Installation suits those with assembly experience: the tower replaces the stock front and rear tower locations using existing chassis mounting points, and commonly reuses the same screws and posts. During fitment hand-start screws and verify shock shaft and body post alignment before final tightening to avoid binding. No supplementary hardware is provided unless the seller states otherwise.