HPI Bullet Front Brace Upgrade for Bullet 3.0 MT ST - BUL-18004-GU by Jazrider  [BUL-18004-GU]

HPI Bullet - Gunmetal Alloy Front Chassis Brace
Price:
£7.84
Brand:
JAZRIDER
Model:
BUL-18004-GU
Condition:
Brand New
Write a review

Front brace detail for HPI Bullet

This RC-scale front chassis brace is intended for the HPI Bullet family and is listed under model BUL-18004-GU by JAZRIDER. The gunmetal alloy brace concentrates stiffness at the front section to support setup changes aimed at improving handling and balance.

The component bolts to the stock front chassis attachment points and is compatible with the Bullet 3.0 MT and ST nitro chassis layout while preserving basic geometry. Its role is targeted and conservative: modify front stiffness to tune turn-in and front-end traction during setup work.

Fitting guidance: verify your chassis mounting points match the specified Bullet variants before installation. Consider this item a structural hop-up for tuning rather than a full chassis replacement.

Which Bullet variants will accept this brace?

The brace is intended for Bullet 3.0 MT and ST models as listed; check your chassis version and mounting layout before purchase to ensure compatibility.

Will I need extra parts to fit it?

Most installations use existing hardware, but slight spacers or different-length screws may be required for perfect alignment on some builds. Inspect fit before final tightening.

Could adding this brace affect my warranty or original parts?

As an aftermarket hop-up, check the original manufacturer's warranty terms. The brace is a tuning upgrade and should not replace any OEM structural requirement without confirmation.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved