HPI Bullet Front C Hub Carrier, Black Alloy - BUL-18001-BK by Jazrider  [BUL-18001-BK]

HPI Bullet - Black Alloy Front C Hub Carrier
Price:
£7.61
Brand:
JAZRIDER
Model:
BUL-18001-BK
Condition:
Brand New
Write a review

Technical Notes on Front C Hub Carrier

This front C hub carrier is supplied as an aftermarket replacement for HPI Bullet models referred to as BULLET 3.0 MT and ST (Nitro Engines). The item is a black alloy front C hub carrier that functions as the steering knuckle mount, joining the front wheel hub to the steering and suspension linkages in the chassis.

Before installation verify chassis compatibility and mounting orientation. The carrier determines hub position and steering pivot, so expect effects on alignment and steering feel; use the vehicle's original hardware where applicable and confirm clearances during test assembly. Standard hand tools such as a hex driver are normally sufficient for removal and refit.

How do I confirm this part fits my chassis?

Check that your vehicle is a BULLET 3.0 MT or ST (Nitro Engines) and compare mounting points and bore sizes to the carrier. If in doubt, compare with the original carrier or consult the seller for compatibility details.

Is this an OEM part or aftermarket?

This listing describes an aftermarket black alloy replacement C hub carrier. It is designed to work as a substitute for the original steering knuckle mount.

Should I expect any setup changes after fitting?

Yes, because the carrier sets hub geometry, confirm wheel alignment and bearing play after installation and adjust linkages as needed to restore desired steering characteristics.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved