HPI Bullet Front C Hub Carrier (for BULLET 3.0 MT & ST) - BUL-18001-GU by Jazrider  [BUL-18001-GU]

HPI Bullet - Gunmetal Alloy Front C Hub Carrier
Price:
£7.56
Brand:
JAZRIDER
Model:
BUL-18001-GU
Condition:
Brand New
Write a review

Front C-hub unit for Bullet 3.0

The BUL-18001-GU front C hub carrier is supplied as a replacement part that fits HPI Bullet 3.0 MT and ST platforms. Constructed in gunmetal alloy, it provides a direct-fit solution for restoring the front suspension mounting points.

This carrier plays a key role in maintaining correct wheel alignment and steering geometry. Swapping the component typically requires removing the front hubs and steering knuckles, installing the new carrier, and rechecking camber and steering linkage alignment to the vehicle's original specifications.

Ideal for routine maintenance or when correcting bent or worn mounting points, the carrier keeps the model's front suspension functioning within its designed parameters.

How does this affect wheel alignment?

Fitting a correctly manufactured carrier restores the intended mounting geometry, which helps bring toe and camber back into the expected range when installed and adjusted properly.

Should I re-check camber after fitting?

Yes. After replacing the carrier you should verify camber and steering linkages and make fine adjustments so both sides match for even handling.

Is this a direct swap without machining?

It is designed as a direct swap using the model's existing fasteners and mounts; no machining should be necessary for proper fitment.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved