HPI Bullet Front C Hub Carrier Orange Anodized (for Bullet 3.0) - BUL-18001-OR by Jazrider  [BUL-18001-OR]

Front C hub carrier for HPI Bullet 3.0 — product notes

This front C hub carrier is an alloy replacement for HPI Bullet platforms, finished in orange anodize. It connects the steering knuckle to the front suspension upright and is aimed at BULLET 3.0 MT and ST chassis, including nitro-powered variants.

Material selection: alloy construction with an orange anodized finish reduces wear where hinge pins and ball studs contact the carrier and provides a more stable seating surface for steering components compared with many stock plastics.

Intended fit: made to suit the front suspension assembly layouts used by Bullet 3.0 MT and ST models. Where the HPI mount points are identical to the original, the carrier accepts the same hinge pins, ball studs and linkage geometry for direct installation.

Fitting advice: remove the factory C hub and carry over bearings, wheel hex, hinge pins and steering linkage hardware as required. After fitting, check wheel toe and steering throw for any interference or binding through suspension travel. A stiffer hub carrier can help deliver steadier steering response and make setup changes more predictable.

Note that packing and included parts differ by retailer; confirm contents before installation.