HPI Bullet JAZRIDER BUL-18008-OR Orange Rear Chassis Brace - Reinforced Rear Section  [BUL-18008-OR]

HPI Bullet - Orange Alloy Rear Chassis Brace
Price:
£8.71
Brand:
JAZRIDER
Model:
BUL-18008-OR
Condition:
Brand New
Available in warehouse
Write a review

Improve rear chassis rigidity with this JAZRIDER brace

The JAZRIDER Orange Alloy Rear Chassis Brace is an upgrade piece for HPI Bullet users wanting firmer rear-end stability. Specifically matched to the Bullet 3.0 MT and ST nitro chassis, it adds structural support without unnecessary bulk.

Purpose built for Bullet 3.0 MT and ST

Produced from a high quality alloy, the brace resists common wear and flex while remaining lightweight. The orange coating assists quick visual checks during setup and repairs.

Straightforward fit and assured compatibility

Fitting uses the stock mounting points so no cutting or custom work is normally required. The brace is sized for HPI Bullet 3.0 MT and ST nitro models for a reliable fit and consistent alignment.

Is the brace compatible with aftermarket rear mounts?

Compatibility depends on the aftermarket mounting geometry. Check that the replacement mounts maintain the factory hole positions if you plan to use this brace.

Does it affect chassis tuning?

Adding rear stiffness can change handling balance. Expect a firmer rear feel; minor suspension or differential adjustments may be useful to tune handling back to your preference.

What should I check after installing?

After fitting, confirm all bolts are torqued correctly and check clearances around the exhaust and fuel tank on nitro models to avoid contact during operation.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved