HPI Bullet Precision 14mm Wheel Hex for BULLET 3.0 MT/ST - BUL-18013-BK by Jazrider  [BUL-18013-BK]

HPI Bullet - Black Alloy 14mm Wheel Hex
Price:
£5.18
Brand:
JAZRIDER
Model:
BUL-18013-BK
Condition:
Brand New
Available in shop
Write a review

Fitment and Compatibility Notes

The BUL-18013-BK is a precision 14mm wheel hex supplied as a black alloy replacement for HPI Bullet applications. It is intended to fit the BULLET 3.0 MT and BULLET 3.0 ST wheel hubs and acts as a direct-fit component for wheel mounting and routine replacement.

Fit the hex by removing wheel and hub fasteners, sliding the hex onto the hub splines until it seats, and then reattaching the wheel nut or lockring. After fitting, check hub alignment, spline engagement and wheel runout before normal operation.

Confirm compatibility with your wheel and hub combination; correct hex seating reduces wheel runout and handling inconsistency. Inspect the hex and mating surfaces regularly and replace items showing significant wear.

Is this hex suitable for both MT and ST Bullet variants?

Yes. The hex is profiled to engage the hub splines on both BULLET 3.0 MT and BULLET 3.0 ST models as listed, making it suitable for those chassis when the hub interface is standard.

Can I use aftermarket wheels with this hex?

You can use aftermarket wheels that accept a 14mm hex interface; ensure the wheel bore matches the hex profile and that the wheel is secured to the hub with the correct nut or lockring to prevent slippage.

What checks should I make after fitting?

Verify spline seating, confirm thread engagement and torque, then spin the wheel to check for runout or wobble. Recheck after a short test run and retighten if necessary.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved