HPI Bullet Rear Chassis Brace, Rear Fitment for Bullet 3.0 MT/ST - BUL-18008-GU by Jazrider  [BUL-18008-GU]

HPI Bullet - Gunmetal Alloy Rear Chassis Brace
Price:
£8.59
Brand:
JAZRIDER
Model:
BUL-18008-GU
Condition:
Brand New
Write a review

Rear fitment and compatibility overview

This rear chassis brace is an RC-scale replacement item intended for HPI Bullet platforms and produced by JAZRIDER under model BUL-18008-GU. The gunmetal alloy brace is designed to increase stiffness at the rear section of the chassis on Bullet 3.0 MT and ST nitro variants.

Compatibility notes: the part is designed to mount to the factory rear mounting points. It is a structural reinforcement and not a drive-train or electronic component, so compatibility focuses on rear bulkhead and mount geometry rather than powertrain differences.

Before fitting: verify there is no interference with exhaust routing or the fuel tank in nitro configurations, align the brace with rear bulkhead fasteners, and consider thread locker on metal-to-metal fasteners. Recheck chassis geometry after installation as the new stiffness may require minor suspension adjustments.

Does this brace fit modified Bullet chassis or only stock mounts?

The brace is intended for stock rear mounting points on HPI Bullet 3.0 MT and ST. Modified chassis may require checking hole spacing and possible minor alterations to ensure correct fitment.

Will I need to move the fuel tank or exhaust to fit it?

On some nitro layouts there may be close clearance to the exhaust or tank; verify clearance before final assembly and adjust routing if necessary to avoid contact.

Are additional brackets or spacers included or required?

The brace uses factory rear mounting points and typically requires no extra brackets. If your Bullet has non-standard mounts you may need adapters or spacers to achieve proper alignment.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved