HPI Bullet Rear Mount Brace Compatible with BULLET 3.0 MT and ST - BUL-18008-BK by Jazrider  [BUL-18008-BK]

HPI Bullet - Black Alloy Rear Chassis Brace
Price:
£8.66
Brand:
JAZRIDER
Model:
BUL-18008-BK
Condition:
Brand New
Write a review

BULLET 3.0 rear chassis support

This alloy rear chassis brace is an RC-scale replacement produced to fit HPI Bullet platforms. It provides targeted rear chassis reinforcement to limit flex during heavy use, improving chassis integrity during cornering and impact events.

Manufactured in black alloy, the brace stiffens the rear mounting area to better support suspension linkages and related fittings. It covers BULLET 3.0 MT and ST variants within the HPI Bullet family; confirm your vehicle designation before purchase.

Installation is aimed at hobbyists familiar with hop-up upgrades and uses the vehicle's existing rear mounting holes. Typical installation requires a correct-sized hex driver and basic hand tools, and a follow-up suspension check is advised to rebalance the setup.

Which Bullet 3.0 variants will accept this brace?

The product is intended for BULLET 3.0 MT and ST variants in the HPI Bullet series. Double-check your model code and chassis layout to verify compatibility.

Any setup tips after fitting?

After fitting, review rear ride height and damping to accommodate the increased rear stiffness. Make incremental changes and test a few runs to settle the new balance.

Is the brace suitable for competitive use?

Yes, it is suitable as an aftermarket upgrade to reduce flex and improve repeatable handling, but evaluate its effect on your specific race setup before committing to wider changes.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved