HPI Savage C-Style Alloy Hubs (Purple) JR-CHP-SAV-031 by Jazrider  [JR-CHP-SAV-031]

Alloy C Hubs (Purple) For HPI Savage Nitro Off Road Series - Jazrider Brand [JR-CHP-SAV-031]
Price:
£20.80
Brand:
JAZRIDER
Model:
JR-CHP-SAV-031
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Upgrade hubs for HPI Savage chassis

These purple-colour alloy C hubs are supplied as an aftermarket replacement for HPI Savage Nitro Off Road series vehicles. Manufactured from aluminium alloy, they serve the steering knuckle and lower suspension link attachments on Savage chassis employing C-style hub geometry.

The aluminium construction reduces flex compared with factory plastic hubs, helping to preserve suspension geometry under load. The purple finish is decorative and does not modify the mechanical interface. When reinstalling, use original mountings if fitment and condition are acceptable.

Fitting advice: remove wheel and hub carrier fasteners, extract the original C hub and replace with this alloy component, taking care to check castellated nuts, set-screws, and bearing clearances during reassembly. Verify steering sweep and droop across full travel after installation.

Specifications

  • Item: Alloy C Hubs (Purple)
  • Material: Aluminium alloy
  • Model Number: JR-CHP-SAV-031
  • Compatibility: HPI Savage Nitro Off Road Series

If you need firmer hub behaviour and a personalised look for your HPI Savage, these alloy C hubs are a straightforward aftermarket swap; check chassis-specific fit before use.

Which Savage variants are covered by compatibility?

They are listed for HPI Savage Nitro Off Road series models; confirm by comparing the hub geometry of your chassis to the C-style design prior to purchase.

Will these hubs work with my existing wheel bearings?

These hubs accept the same bearing seating as stock C hubs, but always check bearing fit and seating depth during installation to ensure there is no pre-load or play.

Are any chassis modifications required?

No chassis modification is intended; the hubs are designed for direct fitment where C-style hubs are used. If clearances differ, inspect surrounding components for interference.

How do I confirm correct orientation when fitting?

Match the hub's mounting faces to the wheel carrier and steering knuckle, check that castellated nut and set-screw positions allow full travel, and verify alignment under load once assembled.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved