This JAZRIDER H HPI-86152 dog bone serves as an RC drivetrain replacement designed for HPI Savage X compatibility, provided as 1 pcs with a silver finish. Its purpose is to replace worn drivetrain links and re-establish reliable power transfer from gearbox outputs to wheel hubs while keeping original chassis geometry intact.
Fitting is made straightforward for those familiar with Savage X mechanics: remove the wheel hub or driveshaft retaining pins, extract the worn dog bone, then fit the JAZRIDER H replacement ensuring it seats correctly in the outdrives and hex cups. Check for clearance at full suspension droop and confirm retention clips or set-screws after the first short run.
In setup terms, this reinforced dog bone reduces slack at mating surfaces to stabilise throttle response and provides enhanced joint strength for higher load situations such as hard launches or rough-surface driving. Use it as a direct swap or as a spare for quick field changes.
Notes: carry out routine inspections of the pin ends and hex interface and replace the part if deformation is observed. This product is intended for RC use only and is not suitable for real vehicles.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
