HPI Savage X Drivetrain Cup Joint 8x14x19 Upgrade HPI-86277 by Jazrider  [HPI-86277]

Price:
£0.00
Brand:
JAZRIDER
Model:
HPI-86277
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Savage X cup joint replacement

The HPI-86277 cup joint is offered as a direct replacement for HPI Savage X drivetrains, presented in a silver finish and sized 8x14x19mm. Confirm the dimension before replacing to ensure the part matches your existing cup joints and yoke clearances.

How to install: remove the driveshaft, change one side at a time to retain alignment, seat the new cup joint correctly in the yoke, then reassemble with original fixings following factory torque guidance. Standard hobby tools are adequate for the swap.

Inspection advice: monitor these joints for scoring and increased play, keep the mating areas free from grit, lubricate sparingly where required, and swap them out in matched pairs when wear becomes evident to preserve driveline geometry.

Will this fit different Savage generations?

It is aimed at HPI Savage X variants; verify that the 8x14x19mm dimension and yoke interface match across generations before assuming interchangeability.

How can I confirm the correct orientation when fitting?

Check the yoke and driveshaft indexing, align the joint so that the mating faces sit flush, and rotate the assembly by hand to verify smooth articulation before tightening final fasteners.

What are the first signs these need replacing?

Noticeable axial or rotational play, scoring on the mating surfaces, or a clunk under load are clear indicators that replacement is required.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved