This alloy front/rear C-Hub is intended for use on HPI Savage vehicles and forms the steering knuckle mount within the suspension. It is offered as an aftermarket replacement to repair broken C-Hubs or refresh worn steering linkages without any claim of OEM manufacture.
Forged in aluminium alloy, the hub takes standard king pins and is supplied with the small securing hardware needed for installation on steering arms and axle mounts. Replacing worn plastic knuckles with alloy items helps keep alignment consistent under load and reduces play.
Installation guidance: inspect king pin clearance and e-clip seating, tighten fasteners to appropriate torque consistent with your chassis hardware, and recheck wheel alignment and toe following installation. Do not overtighten pivot bolts to avoid steering bind.
This GPM alloy C-Hub replaces worn front or rear knuckles on supported Savage variants; perform alignment checks after fitting and keep spare king pins and e-clips for routine upkeep.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
