HUDY 108213 - 449x562mm Plastic Set Up Board Decal for 1/8 Off-Road & Truggy  [HSP-108213]

HUDY 108213 - Plastic Set Up Board Decal 449x562mm - 1/8 Off-Road & Truggy
Price:
£17.90
Brand:
HUDY
Model:
HSP-108213
Condition:
Brand New
Write a review

Replacement setup decal tailored to 1/8 off-road and truggy work

This decal replaces the surface of HUDY flat setup boards with a durable, slick layer that rejects fluids and dirt so layout marks stay clear through tuning sessions. A 1 mm grid and accurate reference lines are printed to support repeatable track-width, toe, and alignment checks on 1/8 off-road cars and truggies.

Use the decal for wheelbase marking, track-width measurement, and symmetry checks while adjusting suspension and steering components. The smooth plastic face helps measurement tools glide without binding, and the printed grid simplifies recording small setup changes between runs.

Specifications

  • Item: Plastic Set Up Board Decal
  • Material: Tough plastic
  • Model Number: 108213
  • Compatibility: #108202 Flat Setup Board, 1/8 Off-Road & Truggy
  • Dimensions: 449 x 562 mm
  • Grid: 1 mm markings

The HUDY decal is a dependable, low-upkeep surface that helps improve measurement accuracy and repeatability for 1/8 off-road and truggy setup routines.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this decal fit HUDY flat setup board #108202 without trimming?

The decal is produced to match the dimensions of reference #108202 so it should sit correctly on the board; check alignment during fitting and trim only if necessary.

Are there any restrictions on tools used on the decal?

Standard measuring tools like calipers and straight edges are fine to use; avoid dragging abrasive edges which could eventually wear the printed grid.

How should I maintain the decal to prevent marking and stains?

Clean with a soft cloth and mild detergent after sessions to remove grease and fluids; avoid solvents and rough scrubbing to keep the print intact.

Does this surface affect magnetic setup tools or jigs?

The plastic decal is non-magnetic and should not interfere with magnetic jigs, but ensure contact points are clean to maintain good tool seating.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved