HUDY 294153 Ultra-Light Hard Coated Aluminium Pinion 53T 64 Pitch  [HSP-294153]

HUDY 294153 Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 53T / 64
Price:
£19.65
Brand:
HUDY
Model:
HSP-294153
Condition:
Brand New
Write a review

Improve Gear Response with the HUDY 294153 Pinion

The HUDY 294153 Aluminium ULTRA-LIGHT pinion is aimed at model racers who want a lighter gearbox component without compromising strength. With 53 teeth at 64 pitch, it reduces rotating inertia for more immediate throttle reaction.

Hard Coating Benefits Explained

A hard coating on the pinion reduces abrasive wear and helps the gear keep a clean tooth profile during extended runs. That stability is useful when running repeated sessions or fine-tuning gear ratios for lap consistency.

Intended Fit and Typical Uses

This pinion suits a variety of 1/10 scale cars running a 64 pitch system and performs well on tarmac or prepared club tracks. Always verify pitch and shaft compatibility to ensure correct engagement and avoid damage.

Specifications

  • Teeth Count: 53T
  • Pitch: 64
  • Material: Aluminium
  • Coating: Hard Coated

For drivers seeking a dependable, low-mass pinion, the HUDY Aluminium ULTRA-LIGHT part gives a practical blend of durability and improved acceleration response.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I set gear mesh with this pinion?

Start with a small washer or shim to establish a slight clearance, then tighten and check mesh by rotating the drivetrain. Aim for minimal backlash and no binding to limit premature wear.

Can I pair this pinion with any motor for better acceleration?

Acceleration depends on the whole setup. The pinion reduces rotating mass, which helps, but matching motor, ESC and final drive ratio is essential to see meaningful gains without overloading components.

Does the HUDY 294153 need special lubrication?

Use standard gear-safe lubricants sparingly on the mesh where recommended. The hard coating reduces wear, but correct lubrication and clean running conditions will extend service life.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved