HUDY 294160 60T Hard Coated Aluminium Pinion Ultra-Light  [HSP-294160]

HUDY 294160 - Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 60T / 64
Price:
£20.78
Brand:
HUDY
Model:
HSP-294160
Condition:
Brand New
Write a review

Performance-focused HUDY 294160 pinion gear

The HUDY 294160 pinion is machined from 7075 T6 aluminium and treated with a hard coating to offer a light, wear-resistant option for RC drivetrains. It aims to improve rotational efficiency while maintaining tooth strength.

What the HUDY 294160 delivers

Its reduced weight helps the motor accelerate quicker and improves transient response, while the hard coat helps the gear resist surface wear from repeated use.

Built for regular track sessions

Constructed to stand up to frequent running, the HUDY 294160 provides consistent meshing and is suitable for racers who regularly tune and maintain their gearboxes.

Specifications

  • Material: 7075 T6 Aluminum
  • Teeth Count: 60T
  • Coating: Hard Coated

For any 1/10 scale competitor looking to reduce rotating mass without losing durability, the HUDY 294160 is a sensible component to consider.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this pinion work with my standard 1/10 touring car?

It will suit many standard 1/10 touring car setups, but verify motor shaft diameter and bore type before purchase.

How do I check for proper gear mesh after fitting?

Place a thin layer of grease on spur teeth, mesh the pinion and spur, rotate to seat, then leave a small clearance and tighten fasteners.

Is aluminium safe for high torque electric setups?

Aluminium can work well and save weight, but monitor for tooth wear under sustained high torque and consider periodic inspection.

Any advice on securing the pinion to the shaft?

Ensure set screws are tightened to spec, use thread locker where appropriate, and recheck after a couple of runs to confirm stability.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved