Inferno MP Series MP9 TKI4 Narrow Wheel Hub Upgrade for Track Width Adjustment - Kyosho IFW326BL  [KY-IFW326BL]

Kyosho IFW326BL - Wheel Hub(Narrow/777/Blue/4Pcs)
Price:
£0.00
Brand:
Kyosho
Model:
KY-IFW326BL
GTIN:
4955439011515
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Replacement Narrow Wheel Hub for MP9 TKI4 Models

The Kyosho IFW326BL narrow wheel hub is supplied in a pack of four and is designed for use on the Inferno MP Series MP9 TKI4. The blue finish corresponds to the IFW326BL code and the hubs are intended where a reduced offset is needed.

In operation the hub locates the wheel with respect to the axle and suspension arms and is a core part of the wheel assembly. When fitting replacements inspect the wheel hexes and 走珠軸承 for wear, ensure the hub seats correctly on the hex and axle, and apply the vehicle manufacturer's torque settings to fasteners to prevent looseness or binding.

Fitment notes: remove wheel and hex, place the hub onto the axle or stub, check bearing alignment, and retain with the original hardware. If any wheel play is noticed after installation, check hex seating and bearing condition before changing suspension geometry.

Handling effect: a narrower hub decreases track width and can subtly alter steering response and cornering balance. Use narrow hubs to refine handling, and re-check toe and camber after making hub changes.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does the IFW326BL pack include enough hubs for all four wheels?

Yes, the IFW326BL is supplied as a set of four hubs so you can replace the hubs at each wheel position on a typical buggy.

Are these hubs compatible with other chassis variants?

These parts are specified for the Inferno MP Series MP9 TKI4. Measure and compare the mounting geometry if you plan to fit them to other chassis variants.

When should I replace bearings while changing hubs?

If bearings show any roughness, play or contamination, replace them. Clean bearing seats and ensure correct seating to avoid premature wear.

What alignment checks are recommended after installation?

Verify wheel runout, bearing seating and front/rear toe and camber settings, then perform a controlled test run to confirm there is no binding before full operation.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved