Jazrider JR-HAG-TX500-011 Precision Stabilizer Bar for Align T-Rex 500  [JR-HAG-TX500-011]

Align T-rex TRex 500 parts - Stabilizer Bar - Jazrider Brand [JR-HAG-TX500-011]
Price:
£6.97£11.32
Brand:
JAZRIDER
Model:
JR-HAG-TX500-011
Condition:
Brand New
Available in warehouse
Write a review

Precision Handling with the Jazrider JR-HAG-TX500-011 Stabilizer Bar

The Jazrider stabilizer bar is tailored for Align T-Rex 500 models and helps deliver tighter control and a steadier hover. It is a straightforward way to refine your helicopter's feel without heavy modification.

Design and Fitment

Engineered to match the T-Rex 500 head geometry, the stabilizer bar reduces minor oscillations and improves tracking. It mounts to the stock head arrangement and supports precise cyclic response.

Installation and Care

Attach the stabilizer bar following basic assembly checks: secure all fasteners, confirm smooth pivot action and recheck alignment after a few sorties. Routine inspections will keep performance consistent.

Will this improve my hover stability?

Yes. The bar helps steady small disturbances and makes hovering easier to trim, especially in gusty conditions.

Do I need special tools to fit it?

Only basic hand tools and a torque driver for small screws. No specialised workshop equipment is required for standard fitting.

Can I tune it for aggressive 3D flight?

The bar stabilises the head but does not replace pilot setup. Combine with careful swash and gyro tuning for aggressive flying styles.

How often should bearings be checked?

Check bearings and pivots every few flights and after any hard impact. Replace parts that show wear to avoid handling degradation.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved