Supplied as a 2-piece set in red anodized aluminum, these wheel shafts serve as direct replacement axles for the Kyosho Fazer Mk2 FZ02. They offer a metal alternative to some stock materials for those focusing on longevity and repeatable fitment.
Compatibility is limited to the Kyosho Fazer Mk2 FZ02 chassis; always verify wheel hex and hub clearances before committing to installation. These components are intended for model RC applications only.
Installation procedure: disassemble the wheel, replace the original shafts with these units, confirm that wheel hexes and hubs are flush, and check for free rotation without binding. Re-tighten hex screws after a short run to ensure secure fitment.
Adjustment note: the shafts are targeted at maintenance and part-level durability improvements, helping to stabilise wheel interface geometry across service cycles rather than acting as a direct handling tune.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
