Kyosho-Compatible Rear Upper Suspension Arm Set for Fazer Mk2 FZ02 - JR-KFZ205-LB by Jazrider  [JR-KFZ205-LB]

Kyosho Fazer Mk2 FZ02 Aluminum Rear Upper Suspension Arm Set (Blue)
Price:
£6.30
Brand:
JAZRIDER
Model:
JR-KFZ205-LB
Condition:
Brand New
Available in shop
Write a review

Precision Rear Upper Link Replacement

Made for the Kyosho Fazer Mk2 FZ02 platform, this rear upper suspension arm set replaces the factory plastic arms with aluminum units intended for precise on-road tuning. The blue anodized finish is cosmetic and protective while preserving the chassis' original fitment points.

Installation is performed at the existing mounting locations: remove the standard upper arms, inspect ball studs and fixings for wear, install the aluminum arms into the same points, and check that suspension travel remains free and even. Use routine hand tools and verify fastener tightness after a short test run.

As an aftermarket hop-up the arms raise stiffness in the rear upper link, which can affect roll behavior and steering characteristics. Adjust suspension settings stepwise and test systematically to find the handling balance you want.

Are these arms compatible with other Kyosho kits?

They are specified for the Fazer Mk2 FZ02. Some other Kyosho models may share mounting geometry, but always compare part dimensions and mounting points before assuming fitment.

What should I check during initial test runs?

After fitting, listen for binding, check for uneven travel, and re-torque fasteners. Inspect ball studs and joint movement to ensure smooth operation.

Is additional hardware required for fitting?

No extra hardware is normally needed; the arms are designed to use existing mounts and fasteners. Replace any worn ball studs or damaged screws as necessary for secure installation.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved