KC10 Chassis Flanged Pivot Balls 6.8mm 4pcs - Kyosho CL030  [KY-CL030]

Pivot ball flange set sized 6.8mm for KC10

The Kyosho CL030 pivot ball flange is a set of four 6.8mm flanged pivot balls intended for KC10 chassis installations on scale RC cars. Supplied as a 4pcs pack, these parts replace flange-type pivot connections found in steering and suspension linkages.

The flange provides a positive seating face for linkages and knuckles, helping to cut down lateral play compared with non-flanged alternatives when installed correctly. Installing fresh flanged balls restores joint integrity and supports consistent geometry under load.

Installation notes: check that your KC10 steering knuckle or linkage housing accepts a flanged 6.8mm pivot ball, clean seating areas prior to assembly, remove any residue that could prevent full seating, and confirm each joint moves smoothly without excessive looseness after fitting. For best balance, replace multiple worn pivots rather than only one where several show wear.

Tuning role: fitting new pivot balls can reduce unwanted slop, sharpening steering inputs and improving suspension response. Ensure pivot interfaces are free of binding when setting toe, camber, or other alignment adjustments to retain predictable handling.

This 4pcs pivot ball flange pack suits KC10-based setups that call for 6.8mm flanged pivot balls and helps refresh linkage points to maintain reliable handling characteristics on RC models.