KC10 Wheel Hub CL019 4pcs for KC10 - Kyosho  [KY-CL019]

Guide to CL019 hubs for KC10

The Kyosho CL019 wheel hub set is supplied as four pieces for KC10 chassis models, intended to restore secure wheel mounting and support routine servicing. The notes below cover fitment, installation, and how hub condition can affect handling.

Compatibility: specifically matched to the KC10 chassis family, this set maintains consistent wheel placement on both sides of an axle. Prior to fitting, compare hub geometry and wheel hex dimensions to ensure correct clearances and alignment.

Installation notes: remove the wheel and old hub, inspect axle and wheel hex for wear and damage, install the CL019 hub ensuring it seats fully and that retaining hardware is secured, then confirm free rotation without binding. After reassembly, verify wheel offset and track width are within your desired configuration to preserve handling balance.

• Tip: Preserve original wheel hexes and fasteners to retain factory offsets unless intentionally modifying track width.
• Tip: Check bearings while replacing hubs since new hubs will not compensate for worn bearings.
• Tip: Perform a short test drive after installation and recheck fastener torque and wheel alignment.

Compatibility

• KC10 chassis

Keep CL019 hubs as service spares to quickly restore correct wheel mounting on KC10 models and to ensure repeatable handling session to session.