Keen-Fit 1/10 Low-Profile Bumper Black Kyosho VZ022BK  [KY-VZ022BK]

Slim urethane bumper for 1/10 scale

This black urethane bumper is a direct-fit replacement for many 1/10 scale RC cars where a flexible, impact-absorbing front bumper is preferred. The Kyosho VZ022BK combines rebound with form stability to help protect shells and chassis mounting points during routine running and setup tweaks.

It is intended for standard bolt-on bumper mounts used on touring and on-road 1/10 chassis; check hole alignment and fastener compatibility prior to final fitting. The flexible construction reduces transmission of minor impacts into fragile clips and tabs while keeping a low profile for tight clearance setups.

• Material: Urethane (black)
• Part type: Replacement bumper, low-profile
• Compatibility: Fits many 1/10 on-road and touring chassis with standard bolt-on bumper mounts
• Notes: Replaces older part VZ022BL

Mounting and inspection guide

Start by test-fitting and aligning the bumper to the chassis mounting points, then tighten screws progressively to avoid stressing tabs. After gritty or sandy running rinse and dry the bumper and check mounting holes and edges for splits. Replace the bumper if you spot tears or permanent warping to maintain proper mounting geometry.