Kyosho A1271-13R Horizontal Stabilizer Tailplane for Calmato Alpha 40 Red  [KY-A1271-13R]

Kyosho A1271-13R - Horizontal Stabilizer (Calmato Alpha 40 Red)
Price:
£71.82
Brand:
Kyosho
Model:
KY-A1271-13R
GTIN:
4548565503575
Condition:
Brand New
Write a review

Tailplane replacement for Calmato Alpha 40 airframes

This horizontal stabilizer is a direct-replacement tailplane intended for the Calmato Alpha 40 RC model. It provides the correct mounting area and aerodynamic profile for the elevator and is intended as a spare for repair work, routine servicing, or when the original is damaged and must be swapped out.

Installation advice:

  • Check hinge alignment and the stabilizer centreline before adhesive cures; accurate alignment preserves a neutral elevator setting.
  • Verify control horn and linkage geometry so you get full, symmetrical travel without binding; adjust clevises or linkage length to achieve the recommended neutral and throws.
  • Bench-test the servo and elevator travel after fitting and before the first flight to confirm correct direction and limits.
  • Store the stabilizer flat and away from heat to avoid warping; inspect hinge sections and mount points after any impact or heavy landing.

Specifications

  • Part type: Horizontal stabilizer
  • Compatibility: Calmato Alpha 40 RC airplane series
  • Color: Red finish
  • Includes: 1pc
  • Function: Replacement tailplane for pitch stability and trim

Keep a spare stabilizer to limit time grounded - this unit suits crash repairs, preventative maintenance, and finish-matching during rebuilds.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this fit models other than the Alpha 40?

The stabilizer is specified for the Calmato Alpha 40 series. Other models may fit if their hinge spacing and fuselage mount match, so measure mounting points prior to fitting.

Is any fitting hardware supplied?

The item contains one red-finished horizontal stabilizer. Standard fixing hardware and hinges are usually not included unless the product listing specifies otherwise.

Will I need to finish or alter it before use?

The stabilizer comes with a red finish; small trimming of mounting tabs or cleaning hinge slots can be necessary to achieve an exact fit. Repainting is optional for visual matching.

What checks should I perform after installation?

Confirm the stabilizer is level with the fuselage centreline, check elevator neutral at servo centre, and verify equal travel on both sides with trims set to neutral.

How do I know when to replace it?

Replace the stabilizer when you see cracks, deformation or persistent misalignment that cannot be corrected by repair, or if surface integrity is compromised.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved