Kyosho CL005 Rear Shock Stay & Panhard Mount for KC10  [KY-CL005]

KC10 rear shock and panhard mounting overview

The Kyosho CL005 Shock Stay & Panhard Rod Mount is a replacement bracket tailored for the KC10 chassis. It joins the rear shock lower mounts and the panhard rod attachment into a single unit, providing a stable reference point for rear suspension linkage geometry and chassis setup.

The part fits the KC10 rear subframe and acts as a structural anchor for both shock bottoms and the panhard rod. Because it modifies the location and stiffness of these mounting points, drivers use it mainly to tune rear roll centre and lateral axle position rather than as a straight performance upgrade.

Fitment advice: remove the rear bodywork and follow the KC10 disassembly steps to access the mounting area, retain stock hardware if compatible, and ensure the suspension moves freely after assembly. Verify link angles and pivot clearances during reassembly to prevent binding.

Care and setup pointers: inspect mounting faces for signs of wear after heavy running, check fastener torque regularly, and use this bracket to trial small panhard and shock lower changes to refine cornering balance and mid-corner behaviour.

Compatibility Details

Created specifically for Kyosho KC10 chassis variants and intended for use on KC10-based RC-scale models.