Kyosho CL006 Steering C-hub for KC10 chassis  [KY-CL006]

Overview of the KC10 C-hub

This C-hub is supplied as an RC-scale replacement part specifically for the KC10 chassis. It defines the position of the hub carrier relative to the lower suspension arm and steering linkage, so accurate fit and alignment are vital for consistent handling.

Intended use is limited to KC10 chassis types; verify your chassis code before installation. The unit acts as a direct-fit replacement to correct steering geometry following wear or impact and to support setup adjustments during tuning sessions.

Fitting advice: remove the wheel and hub carrier assembly, inspect mounting screws and bushings, transfer any serviceable sealed bearings or shims, and secure the hub using the original mounting points to preserve suspension geometry. Employ the same thread-lock and torque technique you use on other KC10 fasteners to prevent alignment shifts.

Handling effect: replacing a worn or damaged C-hub reduces unwanted play and helps return steering characteristics to their designed state, making it a practical spare for maintenance rather than a performance enhancement on its own.

Keep spare C-hubs available for quick roadside or track repairs to maintain steady KC10 performance across runs.