Kyosho CL026 KC10 Rear Link-Rod Replacement  [KY-CL026]

Kyosho CL026 - Rear Suspension Link-rod (KC10)
Price:
£13.31
Brand:
Kyosho
Model:
KY-CL026
GTIN:
4548565513215
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 £10.63 each £5.35 or 20%
3+ £10.10 each £9.61 or 24%
Write a review

KC10 Rear Link-Rod Overview

This replacement rear suspension link-rod is produced for the KC10 chassis and offered as an RC spare part. It functions as the rear lower/upper link connector and is intended to take the place of the original rear link on KC10 models.

Supplied as a maintenance component for minor repairs and setup work, the link-rod helps hobbyists keep suspension geometry correct. It returns the linkage to its proper movement after wear and can be used when performing modest adjustments to rear toe or roll while leaving other suspension elements unchanged.

Fitting the part is straightforward for users with basic workshop experience: remove the rear wheel, access the suspension arm region, retain and inspect the existing mounting hardware, swap in the replacement link-rod, and ensure the linkage moves freely through its travel before final tightening. This is a model-only component; no special electronics or full-size vehicle tools are necessary.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What basic tools do I need to fit this part?

Basic hand tools are sufficient: remove the wheel with the appropriate wrench, use pliers or a punch for pins if needed, and tighten fasteners to secure the new link. No specialised equipment is required.

Will this replacement change my car balance?

If the original link was worn or bent, replacing it will restore original balance and predictable handling. The part itself is intended for modest tuning and will not dramatically alter balance unless combined with other setup changes.

Can I reuse the original mounting pins?

Often the existing mounting pins and hardware can be reused if they are in good condition. Inspect for wear or damage and replace any degraded components during the installation to ensure correct movement.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved