Kyosho Inferno MP7.5 Rear Gearbox Lower Arm Bulk Alloy 3 Degree - MP75011R3 by GPM  [MP75011R3]

Kyosho Inferno MP 7.5 Option Alloy Lower Arm Bulk For Rear Gear Box(3 Degree ) - 1pc - GPM MP75011R3
Price:
£5.55
Brand:
GPM
Model:
MP75011R3
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Rear lower arm bulk - replacement alloy

This alloy lower arm bulk is intended for the rear gearbox section of the Kyosho Inferno MP7.5 chassis and is supplied as a single item. It substitutes the original lower arm bulk and fixes a 3 Degree orientation to influence rear geometry.

The component fits into the rear gearbox mounting points where it mates with the lower suspension arms and gearbox case. It is a tuning part rather than a redesign of the chassis, so use it alongside varied arm lengths and shock mount settings to refine camber and toe response.

Choosing an alloy bulk improves stiffness compared to plastic originals, aiding alignment under load during spirited cornering. Fit with standard RC tools, confirm fastener torque after installation, and check spur and pinion clearance to avoid contact with the rear gearbox.

Does this replace the OEM lower arm bulk?

Yes, it is designed to replace the stock lower arm bulk on Kyosho Inferno MP7.5 rear gearbox assemblies. Always confirm alignment before final tightening.

Will the fixed angle affect tyre wear?

A fixed 3 Degree orientation can alter camber behaviour and thereby influence tyre wear patterns. Monitor tyre wear after setup changes and adjust alignment as needed.

Recommended post-fit checks?

After fitting, check gear mesh, ensure there is no contact with the gearbox, and re-check fastener torque following the first test runs.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved