The Kyosho LAW93GM front suspension holder D is an aluminum component finished in gunmetal, produced for the LAZER SB family. It acts as a direct-fit mounting point when the original holder is compromised or when a firmer mounting surface is needed for setup consistency.
Its role is to locate suspension arms and shock mounts, preserve alignment under load, and give a repeatable reference for tuning. Fit it to recover factory geometry after impact or to reduce unwanted front compliance during precise setup sessions.
Fitment follows standard front-end service practice: remove the damaged holder, clean mating faces, and transfer any stock bushings or inserts where appropriate. Hand-start mounting screws to ensure correct thread engagement, then tighten to the vehicle maker's recommended values if those are known. Verify travel and steering geometry after fitting and perform low-speed trials before full-power use.
From a tuning viewpoint, a rigid aluminum holder can reduce front flex and help maintain camber and toe under braking and cornering. Use compatible shock mounting positions and arm shims to fine-tune handling rather than relying on softer components to mask issues.
Inspect the holder after impacts for cracks, stripped threads, or deformation. Keep fasteners clean and use thread-lock where suitable for metal-to-metal joints. Replace the part if permanent damage appears to ensure consistent suspension geometry.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
