Kyosho MDW102-04 Aluminium Rear Suspension Holder for MINI-Z AWD DWS - Rear 0 Toe 4  [KY-MDW102B-04]

Kyosho MDW102-04 - Aluminium Rear Suspension Holder(DWS/Caster 0/Toe 4)
Price:
£8.17
Brand:
Kyosho
Model:
KY-MDW102B-04
GTIN:
4548565442980
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 £8.69 each £-1.04 or -6%
3+ £8.26 each £-0.29 or -1%
Available in warehouse
Write a review

Improve Rear Alignment on MINI-Z AWD DWS

The Kyosho MDW102-04 Aluminium Rear Suspension Holder is intended to enhance the rear alignment of the MINI-Z AWD DWS chassis. Fitting this bracket helps maintain consistent geometry, aiding in straighter runs and stable corner exits.

Enhanced Cornering Stability

By reducing flex where the rear suspension mounts, the aluminium holder contributes to steadier cornering behaviour. Drivers will notice improved predictability when threading through complex sections.

Compatibility and Simple Fit

Specifically produced for the MINI-Z AWD DWS, the MDW102-04 offers a direct fit. Installation is straightforward and reversible, letting you test handling changes without permanent chassis alterations.

Can I revert to the original mount after testing?

Yes. The MDW102-04 replaces the original holder using the same points, so you can reinstall the stock part if you prefer the original feel.

Does the aluminium part require special care?

Regular cleaning to remove dirt and occasional inspection for wear is sufficient. Aluminium does not rust like steel, but keep fasteners tight and check for any thread wear.

Will this help on both carpet and hard surface tracks?

Yes. The holder improves rear consistency across surfaces, but you may need to adjust suspension and tyre choices to match the track for best results.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved