Kyosho Mini Inferno Compatible Graphite Rear Damper Plate GMIF030 by GPM  [GMIF030]

Graphite rear damper mount

This graphite rear damper plate is supplied as an RC replacement part for Kyosho Mini Inferno and Mini Inferno 09 platforms, delivered as a single-piece set that includes matching screws and lock nuts. It provides a firm mounting point for rear shock units and helps maintain correct alignment between the shock tower and chassis when setups are altered.

Material role: produced in graphite to balance reduced mass with structural stiffness suitable for small-scale competition and hobby use. This component is intended solely for model suspension tuning rather than any real-world vehicle use.

Compatibility notes: designed to match the Mini Inferno / Mini Inferno 09 shock mounting pattern; confirm the hole spacing on your current shock tower before installation to ensure a direct fit.

Installation procedure: remove the original plate and fasteners, place the graphite plate over the tower mounting holes, and secure with the provided screws and lock nuts. Hand-start the fasteners then tighten progressively to avoid misalignment. Use the correct hex key for the supplied screws and verify lock nut tightness after initial runs.

Tuning impact: swapping to a graphite plate will slightly change the flex behaviour at the rear shock mount and can alter rear-end handling; combine this change with adjustments to springs, oil, and mount positions to refine performance.