Kyosho Mini Inferno Front Arm MIF-033/BU - service and tuning part by 3Racing  [MIF-033/BU]

Front suspension arm overview for Mini Inferno

This front suspension arm is supplied as a compatible RC part for the Kyosho Mini Inferno chassis. It is intended to replace damaged or worn front arms and to restore the steering geometry and suspension travel to their standard configuration.

Fitting is aimed at experienced hobbyists: remove the wheel and hub assembly, detach the current arm from the hub carrier and chassis anchoring points, and refit the new arm with the original fasteners. No additional machining or unusual tools are required.

In tuning terms, the arm determines hub offset, caster and toe link positions and thus affects initial turn-in and corner balance. Fit this arm to recover baseline setup after repair work or to keep setup consistent between events.

For ongoing maintenance inspect pivot pins and mounting holes for wear, ensure fasteners are secure, and confirm there is no excessive play before each run. The blue finish helps identify replaced items during routine checks.