Kyosho Mini Inferno Rear Brace Stiffener MIF-015/TI Performance Part by 3Racing  [MIF-015/TI]

Mini Inferno rear brace stiffener

This silver rear brace stiffener is produced for the Kyosho Mini Inferno and Mini Inferno ST chassis and carries the part code MIF-015/TI. It fits at the rear brace locations to firm the chassis and improve the rear response during tuning sessions.

Fitment is restricted to the models listed and the component uses the vehicle's original mounting points. No permanent chassis modifications are necessary beyond removing the original brace, but verify correct seating before final tightening.

In practice, adding this stiffener alters load distribution to the suspension and diff, so handling balance will change with different shock setups and tyre choices. Make measured setup changes and evaluate on short runs.

Fitment checklist: clear a bench area, gather hex drivers and small screwdrivers, retain factory fasteners, check thread engagement on reassembly, and avoid excessive torque to prevent damage.