Kyosho Mini Inferno / Mini Inferno ST Rear Toe Adjustment Holder 1 Degree MIF-026/TI by 3Racing  [MIF-026/TI]

Rear holder introduction

The MIF-026/TI rear suspension holder is a compact replacement part that fits Kyosho Mini Inferno and Mini Inferno ST chassis and provides a 1 degree rear offset to alter toe settings. Supplied in a titanium-colour finish, it is intended for subtle setup work rather than heavy-duty reinforcement.

Its role is to shift rear suspension geometry slightly to affect rear toe, enabling drivers to fine-tune corner entry and mid-corner stability on carpet and smooth asphalt micro on-road circuits. The holder uses the stock Mini Inferno mounting points and serves as a direct replacement rather than an all-in-one upgrade.

Installation is a straightforward swap: remove the rear linkage fasteners, install the MIF-026/TI holder with the existing bolts, verify thread engagement and alignment, then carry out a wheel tracking check before running. After a short test session recheck ride height and toe and make measured adjustments.

Tuning guidance: a 1 degree offset offers subtle handling changes; expect small increases in rear rotation or bite rather than dramatic shifts. Use this holder when minor toe correction is needed to tidy handling and improve corner behaviour.