KYOSHO Mini-Z AWD Rear Ridge Delrin Wheel 11mm DMZA601RW+1.0 by GPM  [DMZA601RW+1.0]

Mini-z AWD Delrin Rear Wide Ridge Rims (6p, 1.0mm Off set , Width 11mm) - 1pr - GPM DMZA601RW+1.0
Price:
£5.03
Brand:
GPM
Model:
DMZA601RW+1.0
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Rear ridge Delrin wheel for Mini-Z AWD

This wheel is intended for KYOSHO Mini-Z AWD platforms and is identified as DMZA601RW+1.0. The rim is moulded in Delrin, has a six-point mounting pattern, a 1.0mm offset and an 11mm rim width to suit Mini-Z AWD dimensions.

Fitting follows standard Mini-Z procedures: remove the original rim, align the new wheel to the six-point hub and refit using the existing hardware. After installation, check tyre clearance and wheel rotation to ensure nothing contacts the chassis or body mounts.

On-track the wider rear ridge profile alters the rear contact patch and track width, which can help with rear stability and corner exit grip on carpet or small circuits. Make setup changes methodically and keep tyre variables constant for clear comparisons.

Which Mini-Z variants are compatible with this rim?

Compatible with Mini-Z AWD variants that use the six-point rear hub interface, including MR-03 AWD types. Confirm hub and axle dimensions before purchase.

Do I need different wheel nuts or screws?

No special fasteners are normally required; use the original mounting hardware and tighten to a snug fit. Avoid over-torquing which can deform Delrin parts.

How should I evaluate handling changes?

Record baseline lap times and handling notes, then test the new rims with the same tyres and settings. Change one parameter at a time to understand the rim impact.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved