Kyosho PNGS4834 Steel Pinion 34T-48P Performance Part  [KY-PNGS4834]

Kyosho PNGS4834 - Steel Pinion Gear(34T-48P)
Price:
£6.74
Brand:
Kyosho
Model:
KY-PNGS4834
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 £5.82 each £1.83 or 14%
3+ £5.53 each £3.61 or 18%
Write a review

Overview of the Pinion Gear

The Kyosho PNGS4834 is a 34-tooth, 48-pitch steel pinion designed to deliver even power transfer in a variety of RC models. Its profile promotes dependable engagement and consistent driveline behaviour.

Robust Material Choice

Produced from hardened steel, this pinion offers enhanced resistance to wear and deformation under load. The tougher material helps maintain correct tooth contact through repeated runs.

Compatibility Notes and Fitting

The 34T-48P size suits many motors and gearboxes, allowing for a straightforward swap when a replacement is needed. Install with the appropriate hex key and confirm gear mesh before full operation.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this pinion on a brushless motor?

Yes, it can be used on brushless setups provided the shaft diameter and gearbox spacing match the pinion's mounting and pitch requirements.

What indicates the pinion needs replacing?

Look for rounded or chipped teeth, increased noise, or slipping under load; these signs suggest the pinion should be replaced to protect the spur gear.

Should I lubricate the pinion?

Light lubrication on the spur can help reduce wear, but avoid heavy greases that attract grit; keep the mesh clean for best results.

Does pitch affect replacement options?

Yes, maintain the 48-pitch when replacing the pinion to ensure correct tooth spacing with your spur gear and avoid improper mesh.

Any tips for preventing slippage?

Ensure the grub screw is tight, consider a thread locker if appropriate, and verify the shaft set up is free of burrs so the pinion seats securely.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved