What This Part Does
This RC-scale replacement is supplied as a Kyosho UBW006 spare part for the LAZER ZX series. It is intended as a like-for-like service item to replace worn or damaged elements and to restore original mounting geometry without changing intended performance characteristics.
The spare is model-specific and intended to mate with the original mounting points and interfaces on LAZER ZX components, so confirm fit before completing assembly. During installation, make sure linkages and fasteners align, check for free movement in joints, and use thread-lock or washers where the original design specifies them.
Used as part of a methodical setup routine, this replacement helps re-establish baseline handling before any suspension, steering, or drivetrain tuning. Replace only what is worn and verify system operation before further adjustments.
Assembly Tips
Treat the part like any precision RC component: keep small hardware organised and use the correct hex drivers. Refit bolts to appropriate, conservative torque settings, inspect pivot points for unwanted play, and cycle moving parts to check for binding. If the component interfaces with servo, electronic speed controllers, or the motor wiring harness, ensure routing and clearance match the original layout to avoid chafing.
Service and Fault Finding
After initial running, inspect replaced parts for early wear or misalignment. If the model behaves differently after installation, confirm that related linkages and ball bearings are correctly seated and free. For persistent problems, consult Kyosho service documentation or parts diagrams to verify correct orientation and fitment.
