Kyosho LA529 Lazer SB Gear Cover OEM Replacement  [KY-LA529]

Kyosho LA529 - Gear Cover (LAZER SB)
Price:
£8.65
Brand:
Kyosho
Model:
KY-LA529
GTIN:
4548565473724
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 £7.33 each £2.64 or 15%
3+ £6.97 each £5.06 or 19%
Write a review

Kyosho LA529 Gear Shield for Lazer SB

The Kyosho LA529 Gear Cover is produced to fit the Lazer SB chassis and protect internal gears from dirt and grit. By keeping contaminants out of the gearbox, it helps maintain drivetrain smoothness and reduces the need for unscheduled servicing.

Durability on Tough Surfaces

Built to endure typical off-road and track stress, the LA529 adds an extra protective layer that reduces the chance of damage from small impacts and debris. This contributes to more consistent drivetrain behaviour over repeated runs.

Installation and Upgrade Notes

Replacing the original cover with Kyosho LA529 is a straightforward maintenance job. It uses the same screw points and mating faces as the factory part, making it an easy swap when refreshing worn components or fitting upgrades.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How often should I replace the gear cover?

Inspect the cover at each major service and replace it if you find cracks, warping or damaged mounting bosses. Regular checks help prevent internal gearbox contamination.

Will the LA529 cope with wet or muddy conditions?

The cover helps limit ingress of mud and water but is not a full waterproofing solution. After wet runs, clean and dry the internals to prevent corrosion.

Do I need special tools to fit the cover?

Only basic RC tools are required, such as small screwdrivers and a set of hex drivers. Keep thread locks and correct fastener sizes handy for a secure install.

Can this cover be used with reinforced gear sets?

Yes, so long as the reinforced gears do not alter shaft or bearing positions. Verify internal clearances before running at high power to avoid contact.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved