LAZER ZX7.5 Compatible Battery Mount - Kyosho LA408  [KY-LA408]

Kyosho LA408 - Battery Holder (ZX7.5)
Price:
£11.53
Brand:
Kyosho
Model:
KY-LA408
GTIN:
4548565524099
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 £9.29 each £4.47 or 19%
3+ £8.83 each £8.09 or 23%
Write a review

Battery Mount Compatible with LAZER ZX7.5

The Kyosho LA408 battery mount is a direct replacement component for the LAZER ZX7.5 chassis and acts as the interface that locks the battery pack into place. This overview concentrates on fitment, practical installation advice, and how the mount factors into setup and handling without assuming extra details.

Fitment follows the LAZER ZX7.5 standard: the LA408 aligns with the factory battery bay mounting points and uses the original screw positions. During replacement, ensure the unit is oriented so wiring and connector access for the ESC remain clear and confirm the pack sits flush to prevent any body interference.

As a setup tool, the mount fixes battery location and therefore influences longitudinal balance and handling response. Use the LA408 to reliably restore battery placement between test runs; small changes in pack position can upset traction and steering balance on technical on-road circuits.

For service, remove the body shell, release the existing fasteners, fit the LA408, tidy the wiring route, and tighten hardware. Record your LAZER ZX7.5 battery position in setup notes to maintain consistent test conditions.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the LA408 fit all LAZER ZX7.5 chassis variants?

The mount is designed for LAZER ZX7.5 standard battery bay dimensions; verify your chassis variant follows the same mounting geometry before purchase.

How can I confirm correct orientation when installing?

Line the LA408 up with the chassis screw holes, check that connectors remain accessible, and perform a dry fit with the body shell to ensure no contact points are present.

Is any modification required for common battery sizes?

Most standard on-road packs will fit without modification, but confirm pack thickness and length against the LAZER ZX7.5 bay to avoid interference before final assembly.

Where should I check for spare mounting hardware if it is missing?

If screws are not included, use the LAZER ZX7.5 original fasteners or source compatible small machine screws from hobby suppliers; confirm correct thread and length to avoid chassis damage.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved