LOSI LMT 13T/43T Bevel Gear Set Medium Carbon Steel LMT1200S by GPM  [LMT1200S]

TEAM LOSI LMT 4WD SOLID AXLE MONSTER TRUCK ROLLER Medium Carbon Steel Front/Rear Bevel Gear set 13T/43T - GPM LMT1200S
Price:
£21.48
Brand:
GPM
Model:
LMT1200S
GTIN:
4894538374278
Condition:
Brand New
Write a review
alt="TEAM LOSI LMT 4WD SOLID AXLE MONSTER TRUCK ROLLER Medium Carbon Steel Front/Rear Bevel Gear set 13T/43T - GPM LMT1200S" title="TEAM LOSI LMT 4WD SOLID AXLE MONSTER TRUCK ROLLER Medium Carbon Steel Front/Rear Bevel Gear set 13T/43T - GPM LMT1200S"

13T/43T bevel gear replacement for LOSI LMT drivetrains

This medium carbon steel bevel gear set contains the 13T and 43T gears intended for the front and rear transmission housings of LOSI LMT 4WD solid axle monster trucks. It is offered as a direct replacement for worn or damaged bevel gears and as a practical upgrade when restoring model transmissions.

The gears are made from medium carbon steel to provide a balance of tooth strength and wear resistance while preserving original gearbox geometry. The 13T/43T combination is supplied as a matched set for front and rear use, so replace both gears together to retain the correct gear ratio and mesh. This is an aftermarket RC accessory compatible with the LOSI LMT models listed in the compatibility section.

Packing includes

  • Bevel gear set 13T/43T - 2pcs

Original Name / Part No:

LOS242040,LOS242042

Compatible Models

  • LOSI-1/8 LMT 4WD SOLID AXLE MONSTER TRUCK-LOS04022
  • LOSI-LMT SOLID AXLE MONSTER TRUCK-LOS04021
  • LOSI-TLR TUNED LMT SOLID AXLE MONSTE-LOS04027
  • LOSI-LMT 4WD SOLID AXLE MEGA TRUCK-LOS04024

Fit these bevel gears to renew worn LOSI LMT transmission housings and verify mesh and bearing condition during rebuild to support reliable driveline function.

Which LOSI models are covered by compatibility?

Compatibility is listed in the box above and covers the LOSI LMT solid axle variants specified in that section.

Will these handle high-power setups?

Medium carbon steel increases tooth durability over softer materials, but always check drivetrain alignment and supporting parts to ensure the whole system copes with higher loads.

Do I need both gears when replacing?

Yes, the 13T and 43T are matched and should be replaced together to maintain correct gear ratio and mesh across front and rear transmissions.

Any final assembly checks?

After installation confirm smooth rotation, correct backlash, and that bearings show no play; recheck after a short running session to catch any settling issues.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved