Medius X26 Bumper Plate Carbon (Serpent 402182)  [SER402182]

Serpent SER402182 Bumper plate carbon X26
Price:
£0.00
Brand:
Serpent
Model:
SER402182
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

X26 Front Bumper Plate Description

This Serpent 402182 bumper plate is an RC carbon component specified for X26 series parts and is compatible with Medius X26 chassis installations. It positions the front bumper mount and helps distribute impact loads across the front section during light collisions common in practice and race environments.

Material and fit: constructed from carbon fibre to reduce weight while adding lateral stiffness to the front end. Confirm fit by matching the X26 mounting pattern on your Medius X26 chassis before completing installation.

Installation and tuning role: the plate replaces the original bumper plate using the chassis' existing mounting points and modifies how forces transmit into the front bulkhead. Competent tuners include this item when adjusting bumper stiffness and shock settings to refine steering response.

After any incident, inspect for cracks, delamination, and damaged fastener holes; damaged plates should be replaced to maintain consistent handling characteristics.

How precise must the hole alignment be for Medius X26 fitment?

Hole alignment should be accurate to the factory X26 pattern; small misalignments can cause stress on fasteners or uneven seating, so verify measurements before tightening.

What handling changes should I expect after fitting?

Expect a firmer front feel and crisper steering onset as carbon increases front lateral stiffness; evaluate changes incrementally while adjusting shocks or anti-roll settings.

Is any special hardware required?

Standard bumper fasteners used on Medius X26 chassis are normally suitable. Hand-start screws to prevent cross-threading and replace any worn hardware during fitting for secure mounting.

What signs mean the plate has failed structurally?

Visible fractures, layered separation, or deformed mounting holes indicate structural failure; do not continue to use a plate that shows these defects as it will affect handling safety.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved