Mini Spyder RTR EP (SER440001) Replacement Screw M2.5x10 SER440176 Serpent  [SER440176]

Serpent SER440176 Screw PH M2.5x10
Price:
£4.49
Brand:
Serpent
Model:
SER440176
Condition:
Brand New
Write a review

M2.5x10 Phillips replacement for the Mini Spyder chassis

This M2.5x10 Phillips screw is intended as a replacement part for the Mini Spyder Monster truck RTR EP (SER440001). It is suitable where the original M2.5x10 Phillips fastener is required to secure chassis plates, posts and mounted accessories.

Fitting advice: hand-start each screw to verify alignment, then use an appropriate Phillips driver with steady pressure. Do not over-tighten; moderate torque and correct bit engagement reduce risk of head or thread damage. Reinspect after initial use to confirm secure fitment.

Service and repair use: keep a set of spare M2.5x10 screws on hand to quickly restore secure mounting after component changes or crash repairs, maintaining consistency in chassis geometry and handling.

Can this screw be used in other models that list M2.5x10?

It fits any location that specifies an M2.5x10 Phillips screw, but always confirm fit and length against the target part before use, especially where countersinks or thin panels are involved.

What is the correct way to prevent cam-out?

Use a matching Phillips driver in good condition, ensure it is seated squarely in the screw head, and apply controlled torque. Replace worn driver bits to reduce cam-out risk.

Are these recommended for regular maintenance spares?

Yes. Carrying spare M2.5x10 Phillips screws helps with quick repairs and maintains correct mounting points during routine servicing of the Mini Spyder.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved