Mini-Z AWD Rear Knuckle Arm Holder 0.6mm Alloy, 0.2mm Toe Setting - MZA031R+0206 by GPM  [MZA031R+0206]

Precision rear knuckle holder for Mini-Z AWD

This alloy rear knuckle arm holder is an aftermarket replacement tailored to Kyosho Mini-Z AWD chassis, designed to secure the rear hub and set a fixed 0.2mm toe-in. The 0.6mm alloy plate reduces flex compared with thinner parts, maintaining rear alignment through setup and use.

Install this part when you require a repeatable rear toe and a tougher mounting point for the knuckle arm on Mini-Z AWD cars. It takes standard Mini-Z knuckle fittings and swaps in for the original holder to give predictable small-scale alignment for tuning sessions.

Fitting notes and setup

• Verify the plate fits your Mini-Z AWD chassis before final tightening and hand-thread hardware initially to avoid cross-threading.
• The component sets toe to 0.2mm by design, so it acts as a fixed geometry shim rather than a variable adjuster.
• Once fitted, check motor and wiring clearances around the suspension area to prevent interference on AWD arrangements.