Mini-Z AWD Rear Knuckle Arm Mount MR-03 MZA031R-0210 by GPM  [MZA031R-0210]

Alloy rear knuckle arm mount for Mini-Z AWD

This alloy rear knuckle arm holder is an aftermarket replacement for Kyosho Mini-Z AWD cars, supplied as 1 pcs. It keeps the specified geometry of -0.2mm toe out and 1.0mm thickness and is intended for direct replacement at the MR-03 AWD rear knuckle mounting point.

Fit and installation notes: manufactured for Kyosho Mini-Z AWD MR-03 AWD use; confirm your chassis variant before fitting. Standard Mini-Z wheel hub hardware and the original retaining screws can normally be reused. Fit on a clean mounting area and torque the fasteners to the same values used on the stock holder to preserve wheel alignment.

Tuning role: this mount changes rear toe geometry and is useful when adjusting rear steering sensitivity and balance. The alloy construction produces a firmer mounting than plastic parts, which may improve consistency but can change on-track feel; make cautious, small adjustments and verify on a controlled test surface.

Material and care: constructed from alloy; remove debris after runs and check screw points for any loosening. Replace the holder if threads or bearing seats display excessive wear.