MP11 Left-Side 18deg Hub Carrier IF710-L for Kyosho  [KY-IF710-L]

Kyosho IF710-L - Front Hub Carrier (L/18deg/MP11)
Price:
£40.88
Brand:
Kyosho
Model:
KY-IF710-L
GTIN:
4548565518869
Condition:
Brand New
Write a review

Replacement left hub carrier for MP11

The Kyosho IF710-L is specified for the MP11 platform and supplied in a left-side 18deg orientation. As a replacement unit, it preserves the mechanical link between the steering knuckle and the suspension upright to maintain the chassis steering geometry.

Installation is a routine MP11 service job: remove the wheel hub and steering linkage, swap in the IF710-L and reassemble using the original fasteners where suitable. Before final torqueing, verify drive pin engagement and that the steering arm alignment allows full travel without binding.

Regarding setup, the L/18deg designation sets the static steering angle and will affect front toe and scrub offset; use this carrier when matching a planned geometry rather than as a broad performance retrofit. Inspect related components such as wheel bearings, hinge or kingpins, and the servo saver to ensure consistent handling post-install.

This left 18deg hub carrier is intended for repair or maintenance on MP11 chassis, restoring correct steering geometry while leaving other components unchanged.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I confirm MP11 compatibility?

Confirm the mounting points and dimensions against your MP11 chassis; the IF710-L is produced for MP11 fitment as the left-side 18deg carrier.

What does the "L" indicate on the part?

The "L" denotes the left/front-left position on the chassis, so install it on the corresponding side only.

Can I refit the original hardware?

Often the original screws and bearings can be reused, but inspect them carefully and replace any worn items to ensure a safe and reliable reassembly.

Will swapping carriers require further setup changes?

Yes. Because the carrier angle affects steering geometry, check toe and scrub settings after installation and adjust as part of your normal setup routine.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved