MR-03 AWD Rear Toe Linkage for Kyosho Mini-Z - AWD-09 by 3Racing  [AWD-09]

Kyosho Mini-Z AWD Rear Toe In_Out Linkage - 3RACING AWD-09
Price:
£9.37
Brand:
3Racing
Model:
AWD-09
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Rear toe link for MR-03 Mini-Z AWD

This rear toe in/out linkage fits Kyosho Mini-Z AWD chassis and is sold under part number AWD-09 by 3Racing. It is intended as a direct replacement or service part to restore precise rear toe adjustment while keeping original suspension geometry unchanged.

Installation is aimed at hobbyists familiar with Mini-Z work: the rod links the rear hub carrier to the toe mount, allowing toe-in or toe-out settings. Confirm MR-03 AWD fitment, check thread engagement and avoid over-tightening to prevent binding or wear.

In practice, rear toe tuning affects entry and exit behaviour; slight toe-in tends to stabilise straight-line tracking while small toe-out can improve initial turn-in response. Make measured adjustments and test on a flat, consistent surface to find the setup that matches your driving and grip conditions.

Does this replace stock Mini-Z linkage?

Yes, it is designed to serve as a replacement for the rear toe linkage on MR-03 AWD Mini-Z cars, though you should confirm there have been no prior chassis modifications.

Should I use thread locker?

Use a small amount only if needed after you have finalised setup; initial fitting should be tested without permanent locking to allow fine tuning.

What are quick checks after fitting?

Check free suspension movement, confirm toe settings with a ruler or gauge, and run short tests to ensure the handling changes are as expected.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved