MTX4 Tuning Flywheel MTX3-028 by 3Racing  [MTX3-028]

Mugen Seiki MTX4 Light Weight Fly Wheel - 3Racing MTX3-028
Price:
£11.02
Brand:
3Racing
Model:
MTX3-028
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Lightweight tuning flywheel for MTX4

This lightweight flywheel is intended for the Mugen Seiki MTX4 and is listed as part number MTX3-028. Its reduced mass alters the flywheel inertia so the engine accelerates quicker and throttle response becomes more immediate on nitro models.

Installation is routine for experienced hobbyists: remove the body and clutch assembly to access the flywheel, swap the stock unit for MTX3-028, and refit using the existing hardware. Always confirm clutch timing and torque settings from your chassis manual after reassembly to retain reliable drive characteristics.

Setup advice: a lighter flywheel typically sharpens throttle response and shortens rev-up time, which aids clutch and throttle mapping adjustments. Use measured test runs to evaluate changes rather than assuming instant improvements.

Will it fit without machining?

For most MTX4 builds MTX3-028 installs without modification, but confirm hub and clutch clearance for your specific variant.

Does it impact engine braking?

With lower inertia engine braking behavior can feel sharper; pilots should adjust driving inputs during the initial runs after fitting.

Is this a race part or general upgrade?

This is an aftermarket tuning component aimed at refining throttle and clutch response rather than a wholesale power upgrade; test and tune to suit your setup.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved