MUGEN MTX pulley replacement 7075 aluminium - Arrowmax AM-MTX-T2202  [AM-MTX-T2202]

Guide to MTX pulley replacement

This pulley set is an RC-scale replacement designed for use with MUGEN MTX chassis when a hardened 7075 aluminium pulley is needed. It is supplied as a direct-fit choice for MTX drivetrains, allowing enthusiasts to tackle worn contact areas and refine gear engagement without altering the chassis structure.

The component targets transmission tuning tasks: replacing the standard pulley helps you compare engagement characteristics and assess how a harder material stands up to regular use. As with any replacement part, inspect nearby bearings, shafts and mating faces on the MTX to ensure correct seating and alignment before fitting.

Fitting is straightforward for anyone familiar with MTX maintenance: remove the old pulley, check the shaft and bearings, fit the new pulley and confirm it turns freely and meshes properly. Carry out a short low-power test run to check for lateral movement or misalignment, then re-torque fasteners before returning to full running.

Use this pulley when you require a hardened 7075 aluminium contact surface in the pulley position to evaluate lifespan and small changes in drivetrain feedback during setup work.